What do these stand for?
EPA C1H4 C2H4
TCEQ C2H6 C3H6
CEMS C3H8 NC4
HRVOC IC4 SSO
RATA IC5 ARV
H2S C6 TCD
SO2 C7 FID
CO C8
CO2 C9
NO C10
NO2 O2
The periodic table shows all of the ______________ God gave us to work with.
The nucleus holds both ___________ & __________________ .
The _____________ orbit around the nucleus.
How many legs does carbon have? How many Valences?
What’s the first rule of fight club? How many electrons in the first ring?
What’s the second rule of fight club? How many electrons in the second ring?
Who is the smallest guy on the planet? Number 1 on the periodic table?
When two or more elements from the periodic table bond, they become a ________________.
Who is the second smallest? Number 2 on the periodic table?
Who are 6,7, and 8 on the periodic table?
Who is happy Alkane or Alkene?
What is the atomic weight of H2O?
At the beginning of the cycle on a GC we will turn on the SSO/ARV to __________________ to atmospheric pressure.
How long will we do this before injecting the sample?
In a Maxum II GC. What is the typical oven temperature?
On the TCD that we use for the EP Splitter, there are 4 beads. What is the job of bead #1, 2, 3, & 4?
Why must we keep the sample hot? What is a good temperature for the heat trace?
What are two kinds of sample systems?
Purpose of a fast loop?
What is the purpose of column #1 on the EP Splitter?
How big is a micron?
What is the job of a filter?
What type of filter will hold up moisture and allow it to go to the bottom and exit?
Name the filters that are self cleaning?
What type of regulator will cause a liquid to become gas?
Name the part of the chiller that will make the moisture in the air drop below dewpoint?
What pump is on the bottom of the chiller to get rid of liquid?If liquid makes it past the chiller, how do we keep it from getting to the analyzers?
Name the the main analyzers you will see in a CEMS?
Are all three bad?
What are the three ways to measure O2?
What do we look for with Chemiluminescence?
What in the Chemiluminescence analyzer is the main issue when not working?
What analyzer do you use to measure CO?
When a gas absorbs the light from the source and it down not make it to the detector, what does the output do?
This is called _______________________ proportional.
When we cut off the tail of a large peak with the valve opening and allowing the sample to go to the detector, what is this called.
When components are too large to come through the first column, we will then push them to the trash or a different detector, this is called?
In a Maxum II GC. Bead number 1 is used for?
Bead 2?
Bead 3?
We must always try to have a _______________________ sample or otherwise we will not be reading correctly?
The time it takes the GC to run all the components and send the results out is called.
A GC works off of _____________________.
What pushes the sample through the GC?